diff options
Diffstat (limited to 'module')
| -rw-r--r-- | module/zfs/vdev.c | 11 | ||||
| -rw-r--r-- | module/zfs/vdev_disk.c | 15 |
2 files changed, 22 insertions, 4 deletions
diff --git a/module/zfs/vdev.c b/module/zfs/vdev.c index b17682d81..a803833ba 100644 --- a/module/zfs/vdev.c +++ b/module/zfs/vdev.c @@ -1646,6 +1646,17 @@ vdev_open(vdev_t *vd) error = vd->vdev_ops->vdev_op_open(vd, &osize, &max_osize, &ashift); /* + * Physical volume size should never be larger than its max size, unless + * the disk has shrunk while we were reading it or the device is buggy + * or damaged: either way it's not safe for use, bail out of the open. + */ + if (osize > max_osize) { + vdev_set_state(vd, B_TRUE, VDEV_STATE_CANT_OPEN, + VDEV_AUX_OPEN_FAILED); + return (SET_ERROR(ENXIO)); + } + + /* * Reset the vdev_reopening flag so that we actually close * the vdev on error. */ diff --git a/module/zfs/vdev_disk.c b/module/zfs/vdev_disk.c index db765c57b..4ac08c861 100644 --- a/module/zfs/vdev_disk.c +++ b/module/zfs/vdev_disk.c @@ -108,6 +108,10 @@ bdev_capacity(struct block_device *bdev) * case, and updating the partition table if appropriate. Once the partition * size has been increased the additional capacity will be visible using * bdev_capacity(). + * + * The returned maximum expansion capacity is always expected to be larger, or + * at the very least equal, to its usable capacity to prevent overestimating + * the pool expandsize. */ static uint64_t bdev_max_capacity(struct block_device *bdev, uint64_t wholedisk) @@ -122,14 +126,17 @@ bdev_max_capacity(struct block_device *bdev, uint64_t wholedisk) * alignment restrictions. Over reporting this value isn't * harmful and would only result in slightly less capacity * than expected post expansion. + * The estimated available space may be slightly smaller than + * bdev_capacity() for devices where the number of sectors is + * not a multiple of the alignment size and the partition layout + * is keeping less than PARTITION_END_ALIGNMENT bytes after the + * "reserved" EFI partition: in such cases return the device + * usable capacity. */ available = i_size_read(bdev->bd_contains->bd_inode) - ((EFI_MIN_RESV_SIZE + NEW_START_BLOCK + PARTITION_END_ALIGNMENT) << SECTOR_BITS); - if (available > 0) - psize = available; - else - psize = bdev_capacity(bdev); + psize = MAX(available, bdev_capacity(bdev)); } else { psize = bdev_capacity(bdev); } |