1 files changed, 24 insertions, 5 deletions

diff --git a/module/zfs/vdev_disk.c b/module/zfs/vdev_disk.c
index cdb8f78e2..9b51ecc1d 100644
--- a/module/zfs/vdev_disk.c
+++ b/module/zfs/vdev_disk.c
@@ -244,12 +244,12 @@ vdev_disk_open(vdev_t *v, uint64_t *psize, uint64_t *max_psize,
 {
 	struct block_device *bdev = ERR_PTR(-ENXIO);
 	vdev_disk_t *vd;
-	int mode, block_size;
+	int count = 0, mode, block_size;
 
 	/* Must have a pathname and it must be absolute. */
 	if (v->vdev_path == NULL || v->vdev_path[0] != '/') {
 		v->vdev_stat.vs_aux = VDEV_AUX_BAD_LABEL;
-		return (EINVAL);
+		return (SET_ERROR(EINVAL));
 	}
 
 	/*
@@ -264,7 +264,7 @@ vdev_disk_open(vdev_t *v, uint64_t *psize, uint64_t *max_psize,
 
 	vd = kmem_zalloc(sizeof (vdev_disk_t), KM_SLEEP);
 	if (vd == NULL)
-		return (ENOMEM);
+		return (SET_ERROR(ENOMEM));
 
 	/*
 	 * Devices are always opened by the path provided at configuration
@@ -279,16 +279,35 @@ vdev_disk_open(vdev_t *v, uint64_t *psize, uint64_t *max_psize,
 	 * /dev/[hd]d devices which may be reordered due to probing order.
 	 * Devices in the wrong locations will be detected by the higher
 	 * level vdev validation.
+	 *
+	 * The specified paths may be briefly removed and recreated in
+	 * response to udev events.  This should be exceptionally unlikely
+	 * because the zpool command makes every effort to verify these paths
+	 * have already settled prior to reaching this point.  Therefore,
+	 * a ENOENT failure at this point is highly likely to be transient
+	 * and it is reasonable to sleep and retry before giving up.  In
+	 * practice delays have been observed to be on the order of 100ms.
 	 */
 	mode = spa_mode(v->vdev_spa);
 	if (v->vdev_wholedisk && v->vdev_expanding)
 		bdev = vdev_disk_rrpart(v->vdev_path, mode, vd);
-	if (IS_ERR(bdev))
+
+	while (IS_ERR(bdev) && count < 50) {
 		bdev = vdev_bdev_open(v->vdev_path,
 		    vdev_bdev_mode(mode), zfs_vdev_holder);
+		if (unlikely(PTR_ERR(bdev) == -ENOENT)) {
+			msleep(10);
+			count++;
+		} else if (IS_ERR(bdev)) {
+			break;
+		}
+	}
+
 	if (IS_ERR(bdev)) {
+		dprintf("failed open v->vdev_path=%s, error=%d count=%d\n",
+		    v->vdev_path, -PTR_ERR(bdev), count);
 		kmem_free(vd, sizeof (vdev_disk_t));
-		return (-PTR_ERR(bdev));
+		return (SET_ERROR(-PTR_ERR(bdev)));
 	}
 
 	v->vdev_tsd = vd;