Multipath autoreplace, control enclosure LEDs, event rate limiting

1. Enable multipath autoreplace support for FMA.

This extends FMA autoreplace to work with multipath disks.  This
requires libdevmapper to be installed at build time.

2. Turn on/off fault LEDs when VDEVs become degraded/faulted/online

Set ZED_USE_ENCLOSURE_LEDS=1 in zed.rc to have ZED turn on/off the enclosure
LED for a drive when a drive becomes FAULTED/DEGRADED.  Your enclosure must
be supported by the Linux SES driver for this to work.  The enclosure LED
scripts work for multipath devices as well.  The scripts will clear the LED
when the fault is cleared.

3. Rate limit ZIO delay and checksum events so as not to flood ZED

ZIO delay and checksum events are rate limited to 5/sec in the zfs module.

Reviewed-by: Richard Laager <[email protected]>
Reviewed by: Don Brady <[email protected]>
Reviewed-by: Brian Behlendorf <[email protected]>
Signed-off-by: Tony Hutter <[email protected]>
Closes #2449 
Closes #3017 
Closes #5159 

1 files changed, 2 insertions, 0 deletions

diff --git a/rpm/generic/zfs.spec.in b/rpm/generic/zfs.spec.in
index 4e693ea5b..e80f51e31 100644
--- a/rpm/generic/zfs.spec.in
+++ b/rpm/generic/zfs.spec.in
@@ -73,6 +73,7 @@ Requires:       libzpool2 = %{version}
 Requires:       libnvpair1 = %{version}
 Requires:       libuutil1 = %{version}
 Requires:       libzfs2 = %{version}
+Requires:       device-mapper
 Requires:       %{name}-kmod = %{version}
 Provides:       %{name}-kmod-common = %{version}
 
@@ -84,6 +85,7 @@ Conflicts:      zfs-fuse
 BuildRequires:  zlib-devel
 BuildRequires:  libuuid-devel
 BuildRequires:  libblkid-devel
+BuildRequires:  device-mapper-devel
 BuildRequires:  libudev-devel
 BuildRequires:  libattr-devel
 %endif