Illumos #3618 ::zio dcmd does not show timestamp data

3618 ::zio dcmd does not show timestamp data
Reviewed by: Adam Leventhal <[email protected]>
Reviewed by: George Wilson <[email protected]>
Reviewed by: Christopher Siden <[email protected]>
Reviewed by: Garrett D'Amore <[email protected]>
Approved by: Dan McDonald <[email protected]>

References:
  http://www.illumos.org/issues/3618
  illumos/illumos-gate@c55e05cb35da47582b7afd38734d2f0d9c6deb40

Notes on porting to ZFS on Linux:

The original changeset mostly deals with mdb ::zio dcmd.
However, in order to provide the requested functionality
it modifies vdev and zio structures to keep the timing data
in nanoseconds instead of ticks. It is these changes that
are ported over in the commit in hand.

One visible change of this commit is that the default value
of 'zfs_vdev_time_shift' tunable is changed:

    zfs_vdev_time_shift = 6
        to
    zfs_vdev_time_shift = 29

The original value of 6 was inherited from OpenSolaris and
was subotimal - since it shifted the raw tick value - it
didn't compensate for different tick frequencies on Linux and
OpenSolaris. The former has HZ=1000, while the latter HZ=100.

(Which itself led to other interesting performance anomalies
under non-trivial load. The deadline scheduler delays the IO
according to its priority - the lower priority the further
the deadline is set. The delay is measured in units of
"shifted ticks". Since the HZ value was 10 times higher,
the delay units were 10 times shorter. Thus really low
priority IO like resilver (delay is 10 units) and scrub
(delay is 20 units) were scheduled much sooner than intended.
The overall effect is that resilver and scrub IO consumed
more bandwidth at the expense of the other IO.)

Now that the bookkeeping is done is nanoseconds the shift
behaves correctly for any tick frequency (HZ).

Ported-by: Cyril Plisko <[email protected]>
Signed-off-by: Brian Behlendorf <[email protected]>
Closes #1643

1 files changed, 8 insertions, 5 deletions

diff --git a/module/zfs/vdev_queue.c b/module/zfs/vdev_queue.c
index 3f2793ba4..b2cc6b87f 100644
--- a/module/zfs/vdev_queue.c
+++ b/module/zfs/vdev_queue.c
@@ -44,8 +44,11 @@
 int zfs_vdev_max_pending = 10;
 int zfs_vdev_min_pending = 4;
 
-/* deadline = pri + ddi_get_lbolt64() >> time_shift) */
-int zfs_vdev_time_shift = 6;
+/*
+ * The deadlines are grouped into buckets based on zfs_vdev_time_shift:
+ * deadline = pri + gethrtime() >> time_shift)
+ */
+int zfs_vdev_time_shift = 29; /* each bucket is 0.537 seconds */
 
 /* exponential I/O issue ramp-up rate */
 int zfs_vdev_ramp_rate = 2;
@@ -396,7 +399,7 @@ vdev_queue_io(zio_t *zio)
 
 	mutex_enter(&vq->vq_lock);
 
-	zio->io_timestamp = ddi_get_lbolt64();
+	zio->io_timestamp = gethrtime();
 	zio->io_deadline = (zio->io_timestamp >> zfs_vdev_time_shift) +
 	    zio->io_priority;
 
@@ -430,8 +433,8 @@ vdev_queue_io_done(zio_t *zio)
 
 	avl_remove(&vq->vq_pending_tree, zio);
 
-	zio->io_delta = ddi_get_lbolt64() - zio->io_timestamp;
-	vq->vq_io_complete_ts = ddi_get_lbolt64();
+	zio->io_delta = gethrtime() - zio->io_timestamp;
+	vq->vq_io_complete_ts = gethrtime();
 	vq->vq_io_delta_ts = vq->vq_io_complete_ts - zio->io_timestamp;
 
 	for (i = 0; i < zfs_vdev_ramp_rate; i++) {