ztest: split block reconstruction

Increase the default allowed number of reconstruction attempts.
There's not an exact right number for this setting.  It needs
to be set large enough to cover any realistic failure scenarios
and small enough to avoid stalling the IO pipeline and invoking
the dead man detection.

The current value of 256 was empirically determined to be too
low based on multi-day runs of ztest.  The fault injection code
would inject more damage than could be reconstructed given the
relatively small number of attempts.  However, in all observed
cases the block could be reconstructed using a slightly higher
limit.

Based on local testing increasing the default value to 4096 was
determined to strike the best balance.  Checking all combinations
takes less than 10s in the worst case, and has so far eliminated
the vast majority of false positives detected by ztest.  This
delay is roughly on par with how long retries may be performed
to a misbehaving HDD and was deemed to be reasonable.  Better to
err on the side of a brief delay rather than fail to reconstruct
the data.

Lastly, the -Y flag has been added to zdb to make it easy to try all
possible combinations when performing split block reconstruction.
For badly damaged blocks with 18 splits, they can be fully enumerated
within a few minutes.  This has been done to ensure permanent errors
are never incorrectly reported when ztest verifies the pool with zdb.

Reviewed by: Tom Caputi <[email protected]>
Reviewed by: Matt Ahrens <[email protected]>
Reviewed by: Serapheim Dimitropoulos <[email protected]>
Signed-off-by: Brian Behlendorf <[email protected]>
Closes #8271 

1 files changed, 8 insertions, 1 deletions

diff --git a/cmd/zdb/zdb.c b/cmd/zdb/zdb.c
index 1a9303d12..c436139a2 100644
--- a/cmd/zdb/zdb.c
+++ b/cmd/zdb/zdb.c
@@ -100,6 +100,7 @@ extern int zfs_recover;
 extern uint64_t zfs_arc_max, zfs_arc_meta_limit;
 extern int zfs_vdev_async_read_max_active;
 extern boolean_t spa_load_verify_dryrun;
+extern int zfs_reconstruct_indirect_combinations_max;
 
 static const char cmdname[] = "zdb";
 uint8_t dump_opt[256];
@@ -215,6 +216,8 @@ usage(void)
 	    "dump all read blocks into specified directory\n");
 	(void) fprintf(stderr, "        -X attempt extreme rewind (does not "
 	    "work with dataset)\n");
+	(void) fprintf(stderr, "        -Y attempt all reconstruction "
+	    "combinations for split blocks\n");
 	(void) fprintf(stderr, "Specify an option more than once (e.g. -bb) "
 	    "to make only that option verbose\n");
 	(void) fprintf(stderr, "Default is to dump everything non-verbosely\n");
@@ -5871,7 +5874,7 @@ main(int argc, char **argv)
 		spa_config_path = spa_config_path_env;
 
 	while ((c = getopt(argc, argv,
-	    "AbcCdDeEFGhiI:klLmMo:Op:PqRsSt:uU:vVx:X")) != -1) {
+	    "AbcCdDeEFGhiI:klLmMo:Op:PqRsSt:uU:vVx:XY")) != -1) {
 		switch (c) {
 		case 'b':
 		case 'c':
@@ -5903,6 +5906,10 @@ main(int argc, char **argv)
 		case 'X':
 			dump_opt[c]++;
 			break;
+		case 'Y':
+			zfs_reconstruct_indirect_combinations_max = INT_MAX;
+			zfs_deadman_enabled = 0;
+			break;
 		/* NB: Sort single match options below. */
 		case 'I':
 			max_inflight = strtoull(optarg, NULL, 0);