gallium: allow setting of the internal stream output offset

D3D10 allows setting of the internal offset of a buffer, which is
in general only incremented via actual stream output writes. By
allowing setting of the internal offset draw_auto is capable
of rendering from buffers which have not been actually streamed
out to. Our interface didn't allow. This change functionally
shouldn't make any difference to OpenGL where instead of an
append_bitmask you just get a real array where -1 means append
(like in D3D) and 0 means do not append.

Signed-off-by: Zack Rusin <[email protected]>
Reviewed-by: Roland Scheidegger <[email protected]>
Reviewed-by: Jose Fonseca <[email protected]>
Reviewed-by: Marek Olšák <[email protected]>

1 files changed, 3 insertions, 3 deletions

diff --git a/src/gallium/drivers/trace/tr_context.c b/src/gallium/drivers/trace/tr_context.c
index c10e01017fa..3e995980e92 100644
--- a/src/gallium/drivers/trace/tr_context.c
+++ b/src/gallium/drivers/trace/tr_context.c
@@ -1080,7 +1080,7 @@ static INLINE void
 trace_context_set_stream_output_targets(struct pipe_context *_pipe,
                                         unsigned num_targets,
                                         struct pipe_stream_output_target **tgs,
-                                        unsigned append_bitmask)
+                                        const unsigned *offsets)
 {
    struct trace_context *tr_ctx = trace_context(_pipe);
    struct pipe_context *pipe = tr_ctx->pipe;
@@ -1090,9 +1090,9 @@ trace_context_set_stream_output_targets(struct pipe_context *_pipe,
    trace_dump_arg(ptr, pipe);
    trace_dump_arg(uint, num_targets);
    trace_dump_arg_array(ptr, tgs, num_targets);
-   trace_dump_arg(uint, append_bitmask);
+   trace_dump_arg_array(uint, offsets, num_targets);
 
-   pipe->set_stream_output_targets(pipe, num_targets, tgs, append_bitmask);
+   pipe->set_stream_output_targets(pipe, num_targets, tgs, offsets);
 
    trace_dump_call_end();
 }